Discuss anything NSRT4.
barely boosting
09-06-2010 09:23 PM
Tuning device
06-24-2010 09:02 AM
SRT4 oil system diagram
07-22-2010 07:43 AM
Sticky Threads
http://parts.mopar.com/
After the "Turbo..." thread and countless others of people asking for suggested upgrade paths, I figure we could make a thread that will be the...
Normal Threads
This does not happen every time. when I use my right turn signal and it goes off then when I push the brake the brake lights go on and the right...
So a few weeks ago I posted about how I keep breaking my drivers side axle. Since then I have taken to shop to figure out and they're trying to tell...
Hey so i am going to want to change my turbo next year and i am wondering at wat people are getting full boost at and by full boost i mean your top...
Does anyone on here have any experience tuning a Greddy Profec B Spec-II EBC? I just got mine installed on Monday and it seems like every change I...
ok i had my 93 perf tune on my car and it was boosting around 23 or 24psi. i took the tune off cause i was busting vac lines all day amd now my boost...
Car has 94k Good idea to replace the radiator cap when doing the thermostat? Anything else to replace in that area when doing so? Does a new...
Hey guys i need some help. I posted this in the new member section to but I think ill get faster and bettter answers if i just post it here. I have...
I need a stock waste gate for my dsp while on PCM boost. Selling my AGP for $50 + stock wga.. Get at me ASAP. 84seven 421 832five
WTB 255 wally, fuel return line. (Marty, you still make these?) leeemeeeee knoow also where can i get a new fuel filter?
Alright, so now that I am finally part of the DSP club. I figured id start looking into different avenues to get the most power out of the car via...
Well a couple of buddys from work convinced me to go last night cause one of'em just picked up a new 5.0 and my other buddy has a Kennybell R/T...
After snapping my factory motor mount at the track from a little tiny bit of wheel hop.. It is time to order some real solid sexy uber stiff motor...
in the past 2 days ive experienced more 3rd gear issues. im gunna pop the cap off the trans 2mrw and take a peek inside. was wondering if anyone has...
was wondering if anyone could get discounts on parts. i need a 3/4 synchro and 3/4 shift fork, thanks
how do you check for current draw on a vehicle. im trying to trace a short and im pretty sure i figured it out but i'd like some advice from someone...
Well I do believe my slave cylinder might be bad. My question is there supposed to be a part that goes between the rod on the slave cylinder and the...
YAY or NAY???!!! DISCUSS http://i849.photobucket.com/albums/ab53/mrgutierrez88/photo-3.jpg ...
So I just got my new ACT Clutch and the tob fork and pivot ball are on the way. All I need now is the trans fluid and some red loctite. I was...
as of now i have a full blown dual set up but one of the pumps failed a while back.. I would rather go to a intake bosch setup but i dont feel like...
So im looking into picking up a DSP, question is where to have it tuned? Benchmark over Pwerks?
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
